Question Any way to move the form in design view?

Program4Food

Active member
Joined
Nov 22, 2021
Messages
40
Programming Experience
10+
I would like to not have the form in design view anchored top/left, is there any way (other than put it in a window) to have it to say the center right??

I seriously doubt it, my GoogleFu has not revealed the magic to do so..


1638402762774.png
 
Last edited:
I can't say for sure that it's impossible, but I've never seen any evidence that would suggest that that is possible.
I hear ya brother, I seriously doubt you can... but I figured it was worth asking. If I figure it out, or find the info Ill post it here. Dont hold your breath. ;-)

Ill leave the post up a few days and if no one has input Ill pull the "Question" marker so it wont draw attention, being it would be a dead end thread.
 
For runtime, you can change the default start position and/or the location properties. I don't think there's a way to do that in the design view, or at least I've never seen any of the UI designers do it, and I've seen them some things that seem to take the WinForms Designer to its limits.
 
Back
Top Bottom